ScanChannelsBDA-2.0.0.6 finds channels but not MCE

[neez]

Why......

I'm trying to figure out why I can't get MCE to find any channels.

I did a fresh install, and applied RU2 and the RU2 patch. I installed the 1.2.2.7 WHQL Twinhan drivers. I decided against installing the newer 1.2.2.9 drivers, because I didn't have much luck with them last time on an old install of MCE.

Now, for some reason, I can't find any channels. I tried the ScanChannelsBDA to see what the signal strength is. Typically, most of the channels are around 80%. Why is it then that MCE can't see these freakin' channles.

One thing I noticed is that MCE scans a lot quicker than it used to too. Is this something to do with RU2, or is it indicative of a problem ??

Please help...this is starting to drive me bloody mad. All I wanted was an EPG that didn't disappear everyday....not these problems.

[neez]

I just replaced the hacked version psisdecd.dll, and put the original back in its place. I've now found all of the channels.