Help with Oztivo grabber

Jopie · **3rd June 2006, 02:34 PM**

I just set up the Oztivo grabber with Brp v3 and it all seems to be wroking until I try to set up the guide in MCE. I go through the whole install process (with code 0000 etc) and it all finishes correctly. But when I try to get into the guide it gives the following message:

"No channels are available in the guide. Select setup to reconfigure the guide..etc"

MCE doesn't allow me to edit and assign channels.

I have tried a few things but nothing seems to work.

Please help.

Ps. the Oztivo preference page allows you to tick a box that says: "Show season and episode numbers on episode list" which I did tick. that should not cause my problem should it?

Point · **3rd June 2006, 02:39 PM**

See the post I just put up a couple of minutes before you - it may give you some clues - I must be one of the lucky ones as I up and working again with BRP3 and MCEdugg.
Early days but it is looking good

Point

Jopie · **3rd June 2006, 02:47 PM**

Thanks Point but not sure it will help. The grabber grabs the data from the relevant webpage and BRP creates the bin file. MCE seems to upload this bin file without a problem (guide update completes without a problem) but I cannot get into the guide as it gives me the message posted in my first thread.

Any help would be appreciated

MagicFox · **11th June 2006, 08:01 PM**

Have you tried scanning for channels in the settings area?