fatal out of memory error

eddles · **13th May 2006, 03:39 PM**

Hi,

I've followed the Bladerunner/FreeXMLTV installation instructions, and it gets to the point where it's transforming guide data, but I get a "Fatal out of memory error."

Any ideas?

blackjet · **13th May 2006, 03:48 PM**

Hello eddles.
what are your PC specs?
we need more info.

regards blackjet

eddles · **13th May 2006, 03:53 PM**

It's an AMD Sempron 2800+ (1.6GHz) with 512MB of RAM, Geforce FX 5200 Compro Videomate card, etc. I could install another 512MB and see if that helps, but I wouldn't have thought that would be the issue.

eddles · **13th May 2006, 04:04 PM**

Have stuck another 512MB of RAM in (for a total of 1024) and i'm still getting the same issue.

blackjet · **13th May 2006, 04:18 PM**

Hello again.

have you read this thread?. It may help you.
http://www.xpmediacentre.com.au/comm...ht=error+codes

I had a simuliar problem a while back.
I think my problem was that my bios detected my ram incorectly.Which caused my system to have memory issues.
I had to manually set my ram as ddr400.
I can only go on my experiances, so I may be totally off track.

I am sure that someone on this site will come up with the sollution for you .

Regards Blackjet

blackjet · **13th May 2006, 04:20 PM**

P.s it may be a swap file issue also..

eddles · **13th May 2006, 06:59 PM**

My bios doesn't allow me to specift ddr400.

However, i've just worked out that this is a Bladerunner issue, not an FreeXMLTv issue.