Hi
I'm trying to setup BRP3.5 with o2grabber (as I live in Denmark!) but somwhere something goes wrong because I end up with no guides to select in MCE. I have setup o2grabber and it runs perfect and creates xmltv.xml in ..\ehome\BladeRunnerPro\GuideData but still no guides in MCE.
If I then try to run o2grabber via BRP3.5 there is no error-messages but after the run my xmltv.xml is gone. Have tested from commandline to verify that no errors occur.
My channels looks ok if I inspect them with Channel Changer.
The QuickGuide gives me an error though:
Quote:
|
Error: Could not find a part of the path 'C:\WINDOWS\ehome\BladRunnerPro\QuickGuide\QuickGu ide\GhannelInfo.xml'
|
I have then tried to change the settings in QuickGuide.exe.config (tip in another forum) to use fully qualified filenames. This makes QuickGuide able just to run long enough to figure out that xmltv.xml is not in its right place at GuideData because it dissapeared when I ran BladeRunnerPro. After manually grabbing with o2grabber QuickGuide exits with no errors - but still no guides in the list in MCE.
The uninstall-install boogie have already been performed several times! And with no music I might add
